Yes, it’s OBD VR read. Get Identify, and get an Ori, modify Ori and during write tool applies Patch.
For example: VW Caddy 1.6 Somos PCR2.1 unlock by OBD*CAN
Here are PCR 2.1 bench and boot tricore instructions attached as well.
SIEMENS PCR2.1 [ 1796 ] – VW, Audi, Seat, Skoda [Diesel]
Simos PCR2.1 Bench Tricore
Connect the bench box v.2 to the tool and connect the multifunction cable as follows:
To read and write use the following driver:
→ BENCH MODE
→ VW / AUDI / SEAT / SKODA
→ TC1796 – VAG
→ SIMOS PCR2.1
ATTENTION:
In addition to reading/writing the full backup, you can also use this driver to unlock the serial write for the OBD driver “R/W MAPS”:
By loading the EEPROM file, if the software sees that the Eeprom is locked, the following message will be displayed:
Set unlock EEPROM for serial maps programming?
Choosing OK will apply the unlock on the EEPROM and you can also write the ECU in OBD using the serial driver R/W MAPS.
We also remind you that you can also read and write PCR2.1 via OBD using the driver:
SIMOS PCR 2.1 UNLOCK BY OBD *CAN
This driver reads the file with virtual read and unlocks the control unit directly while writing by applying a patch on the micro file during writing.
SIEMENS SIMOS PCR2.1 [ TC1796 INT.F.] – VW, Audi, Seat, Skoda
KT200 Simos PCR2.1 Unlock Boot Tricore
We also remind you that you can also read and write PCR2.1 via OBD using the driver:
SIMOS PCR 2.1 ONLOCK BY OBD *CAN
This driver reads the file with virtual read and unlocks the control unit directly while writing by applying a patch on the micro file during writing.
Kit to use:
– Multifunction cable
– 2 resistances of 560 Ω
– 1 resistance of 1000 Ω
Step 1: Password Search
Connect the pinout below with multifunction cable.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ PASSWORD SIMOS PCR2.1
→ Click on “Find Password” and follow the software messages.
Now that the password has been found it’s possible to read and write the control unit. See next step.
Step 2: Read and Write ECU
Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1796
KT200 Read and Write Bosch EDC17CV41 on ...
KT200 GM Opel Delco E98 ECU Bench Pinout
Документи: Ваксините на Pfizer срещу Ков...
ЗАГАДКИТЕ ОКОЛО НУРГЮЛ – ПОВЕЧЕ ВЪПРОСИ,...